Interpreting Tables; Interpreting Error Table - Omron NY532-5400 Troubleshooting Manual

3 Error Descriptions and Corrections
3-1

Interpreting Tables

Within each source, errors (events) are given by functional classifications. Also, events that are not
errors are given.
Additional Information
For descriptions of the error codes for the motion control instructions and other instructions, refer
to the descriptions of the corresponding event codes. Events that occur for motion control
instructions are given in 3-2 Errors in the PLC Function Module. Events that occur for other
instructions are given in 3-3 Errors in the Motion Control Function Module.
Refer to Relationship between Event Codes and Error Codes on page 1-16 for the relationship
between event codes and error codes.
 Interpreting Description of Events When Using NY-series Controllers
On the Sysmac Studio, the descriptions of events that are common to NY-series Controllers and
NJ/NX-series Controllers are displayed as the descriptions of NJ/NX-series Controllers. Therefore, it is
necessary to interpret the displayed contents when your use an NY-series Controller. Note the following
conditions.
• You cannot connect a CJ-series Unit with NY-series Controllers. In the instructions, skip items related
to CJ-series Units.
• In explanation of the errors, replace the term "CPU Unit" with "NY-series Controller" or "NY-series
Industrial PC."
• NY-series Controllers have no SD Memory Card slots. Instead, they provide the Virtual SD Memory
Card function that uses the Windows shared folder. Therefore, replace the term "SD Memory Card"
with "Virtual SD Memory Card." Refer to the NY-series Industrial Panel PC / Industrial Box PC Setup
User's Manual (Cat. No. W568) for details on the Virtual SD Memory Card function.
• NY-series Controllers do not have the SD PWR and SD BUSY indicators. In the instructions, skip
items related to the SD PWR and SD BUSY indicators.
• NY-series Controllers do not have the RUN, ERR, and LINK/ACT indicators for EtherCAT. In the
instructions, skip items related to the RUN, ERR and LINK/ACT indicators for EtherCAT.
• Replace the NJ/NX-series manuals with the NY-series manuals in the Reference column.
• The unit version of the NY-series Controller is 1.12 or later. If the description of an event contains
information for the relevant unit versions, read the part that is related to the relevant unit versions.
3-1-1

Interpreting Error Table

The contents of the error tables are described below.
Item
Event code
Event name
Meaning
3-2
The event code of the error in the NY-series Controller is given. The codes are
given in eight hexadecimal digits.
The name of the error is given
A short description of the error is given.
Description
NY-series Troubleshooting Manual (W564)