Servo Trace Bit Graphics For Safety Integrated - Siemens SINUMERIK 840D sl Function Manual

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

10.1 Troubleshooting procedure

Servo trace bit graphics for Safety Integrated

The servo trace function is one of the measuring functions in the start–up area.

Using the servo trace, for drive signals and NCK signals, measurements can be

started by entering a measuring time and trigger conditions. The results of the

measurements are then graphically displayed. Two curves can be displayed in

2 graphics. The results of the measurements can be saved in files. Further, the

graphics can be saved as bitmap file in the HMI data manager – or directly printed

Starting the servo trace

The servo trace is called in the operator area "Commissioning/Optimization test/

Servo trace".

Signal selection

When selecting signals, axes and signal names can be selected from the appropri-

ate lists for a maximum of 4 trace channels (trace 1 to trace 4). Trace 1 has a

special significance – a signal must be selected in trace 1 otherwise when the PI

service is started using the vertical "start" softkey, this is negatively acknowledged

from the NCK.

SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition

Sinamics s120