Siemens SINUMERIK 840D sl Function Manual page 415

05.08
FUNCTION TEST PART 1
General function check incl. checking the wiring/programming/configuring
7. Test the shutdown paths
(test the forced checking procedure of the shutdown paths)
8. Test the external stops
9. Test the forced checking procedure of the inputs and outputs
10.Test the Emergency Stop and the safety circuits
11. Test all SPL switching states and associated input/output signals
12.Check the hardware configuration of the PROFIsafe I/O
FUNCTION TEST PART 2
Detailed function test incl. checking the values of the individual SI functions used
13.Test the SI function "safe operating stop" – SBH
(in each case with evaluated measurement diagram and measured values)
14.Test the SI function "safely reduced speed" – SG
(in each case with evaluated measurement diagram and measured values)
15.Test the SI function "safety–related output n < n
(in each case with evaluated measurement diagram and measured values)
16.Test the SI function "safe limit positions" – SE
(in each case with evaluated measurement diagram and measured values)
17.Test the SI function "safe cams" – SN
(check using the diagnostics display or assigned SGAs or with the evaluated
measuring diagrams and measured values)
18.If necessary, test the SI function "external stops"
(in each case with evaluated measurement diagram and measured values)
19.Test the SI function "SBC/SBT"
(in each case with evaluated measurement diagram or measured values/
PROFIsafe I/O)
COMPLETION OF THE REPORT
A report of the commissioning status that was checked is generated with the ap-
propriate counter–signatures
20.Check the SI machine data
21.Log the checksums (axis MD/SPL/PROFIsafe I/O)
22.Completing the NCK commissioning (protect synchronous actions)
23.Completing the commissioning of the PLC
24.Verify the data backup
25.Have the report countersigned
© Siemens AG 2008 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
Commissioning
9.5 Acceptance test
"
x
9-415