Siemens SINUMERIK 840D sl Function Manual page 414

Commissioning
9.5 Acceptance test
Authorized person, acceptance report
All SI functions must be acceptance–tested by an authorized person and the test
results recorded in a test report. The report must be signed by the person who car-
ried out the acceptance tests. The acceptance test report must be kept in the log-
book of the particular machine.
In this context this is a person who is authorized by the machine manufacturer and
who has adequate professional training and knowledge of the safety functions in
order to conduct the acceptance test in a proficient manner.
Documentation, data archiving
In addition to the acceptance report, the following SI relevant data must be archived:
NC machine data
Drive parameters
PLC/NCK–SPL program
S7 configuration
Necessity of an acceptance test
A full acceptance test (as described in this Chapter) must always be carried out
when the functionality of Safety Integrated is commissioned for the first time on a
machine.
Extended safety–related functionality, transferring the commissioned software to
additional series machines, modifications to the hardware, software upgrades etc.
make it necessary to carry out the acceptance test – possibly with a reduced test
scope.
In order to define a partial acceptance test it is first necessary to describe the indi-
vidual parts of the acceptance test and then define logical groups that represent
the components of the acceptance test.
Contents of the full acceptance test
DOCUMENTATON
Documentation of the machine incl. safety functions
1. Machine description (with overview)
2. Details about the control system
3. Configuration diagram
4. Function table
Active monitoring functions depending on the operating mode, the protective
doors and other sensors
Ideally, this table should be the objective and result of the configuring work.
5. SI functions per axis
6. Information about the safety equipment
9-414
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
© Siemens AG 2008 All Rights Reserved
05.08