Siemens SINUMERIK 840D sl Function Manual page 550

Diagnostics
10.3 Safety messages for SINAMICS S120
Remedy
F01656
Response
Acknowledgement
Explanation
Remedy
F01659
Response
Acknowledgement
Explanation
10-550
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
Carry out a POWER ON (power off/on) for all components
– Upgrade the Motor Module software.
– Upgrade the Control Unit software.
– Check the electrical cabinet design and cable routing for EMC com-
pliance.
SI CU: Incorrect Motor Module parameter
OFF2
IMMEDIATELY (POWER ON)
When accessing the Safety Integrated parameters for the Motor Mod-
ule (MM) on the CompactFlash Card, an error has occurred.
Note:
This fault results in a STOP A that can be acknowledged.
Fault value (r0949, decimal):
129: Safety parameters for the Motor Module corrupted.
131: Internal Motor Module software error.
132: Communication errors when uploading or downloading the safety pa-
rameters for the Motor Module.
255: Internal software error on the Control Unit.
Re–commission the safety functions.
– Upgrade the Control Unit software.
– Upgrade the Motor Module software.
– Replace the CompactFlash Card.
Re fault value = 132:
– Check the electrical cabinet design and cable routing for EMC com-
pliance.
SI CU: Write task for parameter rejected
OFF2
IMMEDIATELY (POWER ON)
The write task for one or several Safety Integrated parameters on the
Control Unit (CU) was rejected.
Note:
This fault does not result in a safety stop response.
Fault value (r0949, decimal):
1: The Safety Integrated password is not set.
2: A drive parameter reset was selected. However, the Safety Integrated
parameters cannot be reset as Safety Integrated is presently enabled.
3: The interlocked SH input is in the simulation mode.
10: An attempt was made to enable the SH function although this cannot be
supported.
11: An attempt was made to enable the SBC function although this cannot
be supported.
© Siemens AG 2008 All Rights Reserved
05.08