Siemens SINUMERIK 840D sl Function Manual page 416

Commissioning
9.5 Acceptance test
APPENDIX
Reports/measurement records for FUNCTION TEST PART 1/2
Printouts of the hardware configuration from SIMATIC Step 7 for the PROFIsafe I/O
Alarm logs/servo trace measurements
Archive the following SI–relevant data:
NC machine data
Drive parameters
PLC/NCK–SPL program
S7 configuration
Note
The template in the toolbox is only a recommendation.
An electronic template for the acceptance report is available:
– in the toolbox for SINUMERIK 840D sl
– on DOConCD for SINUMERIK 840D sl
– on the service CD for SINUMERIK 840D sl
The acceptance report is divided into the following sections:
– Plant/system description
– Description of the safety functions
– Test of safety functions
Acceptance report of the hardware configuration
For the PROFIsafe I/O, a printout of the hardware configuration from SIMATIC
Step 7 is required as acceptance report.
For this purpose, in Step 7:
– Open project
– Open hardware
– Select the station/print preview
9-416
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
© Siemens AG 2008 All Rights Reserved
05.08