Siemens SINUMERIK 840D sl Function Manual page 80

Safety Functions Integrated in the Drive
4.8 Acceptance test and acceptance report
Authorized persons, acceptance report
Each SI function must be tested and the results documented and signed in the ac-
ceptance report by an authorized person. The acceptance report must be kept with
the machine logbook.
In this context this is a person who is authorized by the machine manufacturer and
who has adequate professional training and knowledge of the safety functions in
order to conduct the acceptance test in a proficient manner.
Note
S
The information and descriptions regarding commissioning must be carefully
observed.
S
If any parameters are altered by SI functions, the acceptance test must be
carried out again and documented in the acceptance report.
Contents of a complete acceptance test
Documentation (see Chapter 4.8.2)
Machine documentation including the SI functions.
1. Machine description and overview diagram (see Tables 4-4 and 4-5)
2. Safety Integrated functions for every drive (see Table 4-6)
3. Description of safety equipment (see Table 4-7)
Functional test (see Chapter 4.8.3)
Check the individual SI functions used.
1. "Safe Torque Off" function, (refer to Table 4-8)
2. "Safe Stop 1" function (refer to Table 4-9)
3. "Safe brake control" function (see Table 4-10)
Completing the report (see Chapter 4.8.6).
Record the commissioning procedure and provide countersignatures.
1. Check the safety parameters
2. Record the checksums
3. Verify the data backups (archives)
4. Countersignatures
Appendix
Measurement records for functional test parts 1 and 2.
S Alarm logs
S Trace recordings
4-80
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
© Siemens AG 2008 All Rights Reserved
05.08