Siemens SINUMERIK 840D sl Function Manual page 450

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

10.1 Troubleshooting procedure

Bit–coded SI signals

The bit–coded SI signals are principally sub–divided into two groups:

S SI signals where the system allocates the names of the bits (signals: SGE–

NCK, SGA–NCK, SGE–PLC and SGA–PLC)

S SI signals where the user can freely select their names and default names are

entered into an Ini file (F:\hmi_adv\ibsvtsi.ini). If the user wishes to change the

default assignment, he can do this in the file hmi_adv\ibsvtsi.ini or using the

appropriate forms in the operator interface.

These different bit–coded SI signals are parameterized on the operator interface.

The settings do not modify the measurement but only how the results of the mea-

surement are actually displayed in the graphic.

No bit graphics are generated for SI signals that are not bit–coded.

The setting options are accessed using the vertical "bit selection..." softkey:

SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition

Sinamics s120