A.2 References - Siemens SINUMERIK 840D sl Function Manual

Appendix

A.2 References

Table A-1 Range of services for machine manufacturers and end customers
Portfolio
Commissioning
Acceptance report
Approval procedure
Workshop
Hotline
On–site service (local)
A.2 References
/ASI/
Low–Voltage Switchgear and Systems
Catalog
Siemens Drives and Standard Products
Order No.: E20002–K1002–A101–A6
A-584
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
Description of services
The safety functions are commissioned based on the configuration that has
been created. The customer provides the machine so that the drives can be
traversed and the control cabinet is wired according to the configuration.
Based on the submitted configuration documentation and commissioning,
an acceptance report for the safety functions is drawn–up. This includes:
S Description of the machine (name, type, ...)
S Description of the safety and operator concept
S Description of the axis–specific safety functions
S All of the safety functions are tested including the SPL logic
S The test results are recorded
The customer receives the acceptance report as hard copy and on an elec-
tronic data medium.
Support with processing and line of argument for the approval procedure by
certified bodies (e.g. regulatory bodies) or large end customers.
Workshops are held on the subject of machine safety adapted to customer–
specific requirements; if required, these workshops can be held at the cus-
tomer's site. Possible contents:
S Machinery Directive, Standards in general
S C Standards (machine–specific)
S Hazard analysis, risk analysis
S Control categories (acc. to EN 954–1)
S SINUMERIK Safety Integrated
S Configuration, machine data
Commissioning
S
Acceptance report
S
An expert for "SINUMERIK Safety Integrated
line number should series errors or problems occur during installation and
commissioning (start–up).
Experts analyze problems that are encountered on–site. The causes are
eliminated or counter–measures are drawn–up and implemented where
necessary.
®
– function and system description
®
" can be reached at the Hot-
© Siemens AG 2008 All Rights Reserved
05.08