Siemens SINUMERIK 840D sl Function Manual page 569

Hide thumbs Also See for SINUMERIK 840D sl:
Table of Contents

Advertisement

05.08
Remedy
F30652
Response
Acknowledgement
Explanation
Remedy
F30655
Response
Acknowledgement
Explanation
Remedy
F30656
Response
Acknowledgement
Explanation
© Siemens AG 2008 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
Carry out a POWER ON (power off/on) for all components
– Upgrade the Motor Module software.
– Upgrade the Control Unit software.
SSI MM: Monitoring clock cycle not permissible
OFF2
IMMEDIATELY (POWER ON)
The Safety Integrated monitoring clock cycle cannot be maintained due
to the communication conditions requested in the system.
Note:
This fault results in a STOP A that cannot be acknowledged.
Fault value (r0949, decimal):
Only for internal Siemens troubleshooting.
Upgrade the Motor Module software.
SI MM: Align the monitoring functions
OFF2
IMMEDIATELY (POWER ON)
An error has occurred when aligning the Safety Integrated monitoring
functions on the Control Unit (CU) and Motor Module (MM). Control
Unit and Motor Module were not able to determine a common set of
supported SI monitoring functions.
– DRIVE–CLiQ communications has an error or failed.
– Safety Integrated software releases on the Control Unit and the
Motor Module are not compatible with one another.
Note:
This fault results in a STOP A that cannot be acknowledged.
Fault value (r0949, hexadecimal):
Only for internal Siemens troubleshooting.
Carry out a POWER ON (power off/on) for all components
– Upgrade the Motor Module software.
– Upgrade the Control Unit software.
– Check the electrical cabinet design and cable routing for EMC com-
pliance.
SI MM: Incorrect Motor Module parameter
OFF2
IMMEDIATELY (POWER ON)
When accessing the Safety Integrated parameters for the Motor Mod-
ule (MM) on the CompactFlash Card, an error has occurred.
Note:
This fault results in a STOP A that can be acknowledged.
Fault value (r0949, decimal):
10.3 Safety messages for SINAMICS S120
Diagnostics
10-569

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinamics s120

Table of Contents