Siemens SINUMERIK 840D sl Function Manual page 350

Data Description
8.2 Parameters for SINAMICS S120
r9756[0...63] SI message time removed in days
Displays the relative system runtime in days when the safety message was
removed.
See also r9744, r9747, r9748, r7949, p9752, r9753,r9754, r9755, p9759
Unit: Default value:
days –
p9759 SI acknowledge messages, drive object
Acknowledges all safety messages present for a drive object.
Parameter should be set from 0 to 1 to acknowledge. After acknowledgement,
the parameter is automatically reset to 0.
See also r9744, r9747, r9748, r7949, p9752, r9753,r9754, r9755, p9759
Unit: Default value:
– 0
p9761 SI password input
Enters the Safety Integrated password. It is not permissible to change Safety
Integrated parameter settings until the Safety Integrated password has been
entered.
Unit: Default value:
– 0000 hex
See also: F01659 "SI CU: Write task for parameter rejected"
p9762 SI password, new
Enters a new Safety Integrated password. If the Safety Integrated password is
changed it must be acknowledged in the following parameter:
See also: p9763
Unit: Default value:
– 0000 hex
p9763 SI password acknowledgment
Acknowledges the new Safety Integrated password. The new password en-
tered into p9762 must be re–entered in order to acknowledge. After success-
fully acknowledged, the new Safety Integrated password is set with
p9762=p9763=0.
See also: p9762
Unit: Default value:
– 0000 hex
8-350
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
Minimum value: Maximum value:
– –
Minimum value: Maximum value:
0 1
Minimum value: Maximum value:
0000 hex FFFF FFFF hex
Minimum value: Maximum value:
0000 hex FFFF FFFF hex
Minimum value: Maximum value:
0000 hex FFFF FFFF hex
Checksum:
Protection level:
–
3
Data type: Effective:
Unsigned16 –
Checksum:
Protection level:
–
3
Data type: Effective:
Unsigned8 –
Checksum:
Protection level:
No
3
Data type: Effective:
Unsigned32 Immediately
Checksum:
Protection level:
No
3
Data type: Effective:
Unsigned32 Immediately
Checksum:
Protection level:
No
3
Data type: Effective:
Unsigned32 Immediately
© Siemens AG 2008 All Rights Reserved
05.08