Siemens SINUMERIK 840D sl Function Manual page 203

05.08
Parameters: Input/output address
The parameterization of the input/output addresses that an F module occupies in
the input/output address range of the DP master is realized in the properties dialog
box, under:
Dialog: Properties
Tab: Addresses
Input: Start
Output: Start
Note
The following conditions apply to the input/output addresses of an F module:
S Input address for PLC317 > 127
S Input address for PLC319 > 512
S Output address = input address
F parameterization
F parameterization is realized in the properties dialog box under:
Dialog: Properties
Tab: Parameter
Parameters > F parameters
The F parameters of the electronic modules are automatically set to the F monitor-
ing time of the HW Config and cannot be changed.
The displayed values of the F parameters
S F_source_address
S F_target_address
must be entered into the machine data to parameterize the NCK in a subsequent
parameterizing step.
© Siemens AG 2008 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
Connecting Sensors/Actuators
7.2 Connecting I/O via PROFIsafe
7-203