Siemens SINUMERIK 840D sl Function Manual page 527

05.08
Response
Remedy
Program
continuation
27204
Parameter
Explanation
Response
Remedy
Program
continuation
27205
Parameter
Explanation
Response
Remedy
Program
continuation
© Siemens AG 2008 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
10.2 NCK safety alarms for SINUMERIK 840D sl
Mode group not ready
Channel not ready
NC start inhibit in this channel
Interface signals are set
Alarm display
NC stop for alarm
Correct the displayed MD.
The alarm is initiated when booting. No program can be started. Only
delete the alarm with a power on.
PROFIsafe: Double assignment MD %1[%2] – MD %3[%4]
%1 = MD name 1
%2 = MD field index for MD name 1
%3 = MD name 2
%4 = MD field index for MD name 2
A double assignment has been illegally parameterized in the specified
machine data.
$A_INSE are parameterized on several PROFIsafe modules.
MDs involved:
– MD $MN_PROFISAFE_IN_ASSIGN
Mode group not ready
Channel not ready
NC start inhibit in this channel
Interface signals are set
Alarm display
NC stop for alarm
Correct the displayed MD.
The alarm is initiated when booting. No program can be started. Only
delete the alarm with a power on.
PROFIsafe: Number of signals
%1 MD name 1
%2 MD field index to the MD name 1
%3 MD name 2
%4 MD field index to the MD name 2
The parameterized number of signals used must be the same in both
machine data.
Mode group not ready
Channel not ready
NC start inhibit in this channel
Interface signals are set
Alarm display
NC stop for alarm
Correct the MD.
The alarm is initiated when booting. No program can be started. Only
delete the alarm with a power on.
in
MD %1[%2] < > MD %3[%4]
Diagnostics
10-527