116.3.11
Card Format Configuration
Once the reader has been configured using the VeriAdmin software, exit the program. You will then need to
set up card format and encoding for the V-Smart using the access control software. For more information,
please refer to the System Administration User Guide.
A Wiegand card format must be created prior to configuring a smart card format with a Bioscrypt access
control card format. This configuration must match the Wiegand format that the V-Smart reader will output.
The following is the suggested Wiegand 64-bit card format configuration to use with a Bioscrypt access
control application.
Note:
Access control card formats for Bioscrypt smart cards must have the maximum of 64 total
number of bits on card.
After the Wiegand card format is created, define a smart card format to be used during card encoding.
116.3.12
Configure 3G Bioscrypt Reader as an Alternate Reader
Complete the following steps to add a Bioscrypt RS-485 alternate reader in System Administration.
1.
From the Access Control menu, select Readers and Doors.
2.
On the General tab, click [Add].
a.
Enter the Name of the reader.
b.
Select the Panel to which the reader is connected.
Hardware Installation Guide
647
revision 7 —