Table of Contents
Advertisement
Biometric Readers
6.
On the Fingerprint (Bioscrypt) tab, under Secondary template, select the desired settings for Biometric
feature, Security level, and Store image.
Additionally, select the Make duress finger check box. If this option is enabled, you must also select
Activate Duress Finger Mode and Reverse Wiegand Output in SecureAdmin.
7.
Capture biometrics. During enrollment for the secondary template, the fingerprint template image is
displayed for the selected valid active cardholder badge.
115.8
Encoding Configuration
The Bioscrypt 4G V-Station (iCLASS) and Bioscrypt 4G V-Flex (MIFARE) readers can be used for
encoding Bioscrypt (iCLASS) and Bioscrypt (MIFARE) smart-card formats. For encoding the Bioscrypt
(DESFire) smart card format, use the DigiOn24 (MIFARE) encoder configured for "DESFire" Credential
technology. This configuration should be done in System Administration.
1.
In the Card Formats folder configure a Bioscrypt (iCLASS) smart card format with the proper Wiegand
access control card format. The memory configuration can be either 16KBits/16 Application Areas or
16KBits/2 Application Areas. Configuring the Site Key is not required but this is not recommended
due to the obvious security risk. Card layout can be configured for encoding only primary, or primary
and secondary templates.
Or in the Card Formats folder, configure a Bioscrypt (MIFARE) smart card format with the proper
Wiegand access control card format. The memory configuration can be either 16KBits/16 Application
Areas or 16KBits/2 Application Areas. Configuring the Site Key is not required but this is not
recommended due to the obvious security risk.
Or in the Card Formats folder, configure a Bioscrypt (DESFire) smart card format with the proper
Wiegand access control card format. Configuring the Application Master Key is not required but this is
not recommended due to the obvious security risk.
2.
In the Badge Types folder, assign the card format to the badge type.
3.
In the Workstations folder, on the Encoders/Scanners form, configure a bioscrypt type encoder that
supports the Bioscrypt (iCLASS), Bioscrypt (MIFARE), or Bioscrypt (DESFire) application. Be sure to
select the correct COM port, V-Series 4G (COM n).
4.
In the Cardholders folder, click [Encode] to encode a badge. Select the smart card format type and
proper Bioscrypt encoder, encoding an iCLASS 16K card, MIFARE 1K/4K card, or MIFARE DESFire
EV1 card. Verify that badge encoding for the biometrics previously captured by the Bioscrypt device
was executed successfully on the card.
620 —
revision 7
Advertisement
Table of Contents
