Elevator Control - Lenel OnGuard Hardware Installation Manual

LNL-1100-U Input Control Module
50.4.1 Relay Outputs
50.5

Elevator Control

OnGuard hardware is capable of supporting elevator control for up to 128 floors. An elevator reader has an
input/output module that controls the access to floors via an elevator.
The OnGuard software must be configured for elevator control. This can be done from System
Administration by selecting the Elevator check box on the General tab in the Readers and Doors form. The
reader's type, name, port, address, and access panel can all be defined here as well.
294 —
revision 7
Relay contact (DC strike)
Relay contact (AC strike)
[