Specifications - Lenel OnGuard Hardware Installation Manual

Table of Contents

Advertisement

LNL-4420 Intelligent Dual Reader Controller
40

Specifications

The LNL-4420 is for use in low voltage, class 2 circuits only.
Primary Power: 12 to 24 VDC ±10%, 500mA maximum (plus reader current)
-
12 VDC @ 250mA (plus reader current) nominal
-
24 VDC @ 150mA (plus reader current) nominal
Memory and Clock Backup Battery: Volt Lithium, type BR2325, BR2330 or CR2330
Host communication: Ethernet: 10BaseT/100Base-TX.
Downstream communication: Two each, 2-wire RS-485, 2400 to 115200 bps, asynchronous, half-
duplex, 1 start bit, 8 data bits, and 1 stop bit.
Inputs:
-
Two (2) unsupervised, dedicated for tamper and UPS fault monitoring
-
Eight (8) unsupervised/supervised, for door position monitoring, REX inputs or alarm contacts
Relays: Four, Form-C, 5A @ 30 VDC, resistive
Reader interface:
-
Reader power (jumper selectable): 12 VDC ±10% regulated, current limited to 150mA for each
reader or 12 to 24 VDC ±10% (input voltage passed through) current limited to 150mA for each
reader.
-
Data inputs: TTL compatible inputs, magnetic stripe and Wiegand standards supported
-
RS-485 mode: 9600 to 38400 bps, asynchronous, half-duplex, 1 start bit, 8 data bits, and 1 stop bit.
-
LED output: TTL levels, high > 3V, low < 0.5 V, 5mA source/sink max.
-
Buzzer output: TTL levels, high > 3V, low < 0.5 V, low=active, 5mA source/sink max.
Cable Requirements:
-
Power: 1 twisted pair, 18 to 16 AWG
-
Ethernet: CAT 5
-
TTL Reader: 22 to 16 AWG, depending on length and requirements
-
RS-485 (I/O device ports): 24 AWG stranded twisted pair(s) with an overall shield, 4000 feet
(1219 m) maximum
-
RS-485 (Reader port): 24 AWG stranded twisted pair(s) with overall shield, 2000 feet (609.6 m)
maximum
-
Alarm Input: 1 stranded twisted pair, 30 ohms maximum, typically 22 AWG @ 1000 feet (304.8 m)
Environmental:
-
Temperature: Operating: 0° to +70° C (32° to 158° F), Storage: -55° to 85° C (-67° to 185° F)
-
Humidity: 0 to 95% RHNC
Mechanical:
-
Dimensions: 8 x 6 x 0.78 in. (203.2 x 152.4 x 20 mm)
-
Weight: 9 oz. (255 g) nominal, board only
Certifications:
-
UL294 & UL1076 Listed
-
ULC Listed
-
FCC Part 15
-
FIPS 197 Certificate #766
-
CE marking
-
RoHS compliant
206 —
revision 7

Advertisement

Table of Contents
loading

Related Products for Lenel OnGuard

Table of Contents