Table of Contents
Advertisement
29.8
Initial IP Addressing Mode
Set the board for the desired initial IP addressing mode. The board can be initially configured using a fixed
static IP address or an IP address automatically assigned by a DHCP server.
•
Automatic Address Assignment By default, the IP address will be assigned by a DHCP server. The
DNS name is "MAC" followed by the characters of the unit's MAC address.
•
Fixed Static IP Address In order to use a fixed static IP address, Power up the board with DIP switch 2
ON and DIP switch 1 off. This default address cannot be changed. If this is chosen, the default static IP
address is 192.168.0.251.
To communicate with the board using this address, the computer must also be on the same subnet. Usually,
this requires changing the computer's network interface card settings.
Note:
Ensure that DIP switch 1 is off and DIP switch 2 is ON before rebooting to keep board in
default static IP address mode.
29.9
Embedded Web Server
Instead of using DIP switches or jumpers to define communication and addressing, the LNL-2220 can be
configured through the web interface.
29.9.1
Logging in for the First Time
There is one pre-defined user always available by turning DIP switch SW1 ON after power up. When
logging on for the first time, since no other users are defined yet, the default user name and password are
required for configuring this board.
After configuring ports and users, be sure to turn SW1 off to enable the settings you've configured.
Note:
All boards have a static certificate that reflects a static IP address. This causes a warning to
appear initially when trying to log in that states a problem with this website's security
certificate. Although it is not recommended, proceed to the website.
29.9.2
Configuration via Web Page
The Configuration Web Page can be launched from within System Administration (only if an IP address or
host name is specified) or by using a browser to access the programmed IP address. Depending on your
proxy settings, you may have to allow this web page. (For more information, consult your browser's online
help or system administrator for assistance.)
1.
In System Administration in the Access Panels folder, click [Configuration Web Page]. This page will
launch in a browser. (You may also access this page by going to the device IP address from within the
browser.)
2.
Click the link to go to the login page. Log in using your user name and password. (See
Security Enhancements
for more information.)
Hardware Installation Guide
Default Login
161
revision 7 —
Advertisement
Table of Contents
