Table of Contents
Advertisement
HandKey Readers
5.
Select which hand you would like to capture. Click [OK].
6.
Follow the instructions displayed on the HandKey CR. At any time, if you wish to cancel, click [Abort
Capture].
7.
When the status displays, "Biometric template capture completed," click [OK].
8.
After exiting the capture screen, click [OK] again to save the biometric template.
Card Format
Now that the encoder has been set up and the hand geometry template was captured, the card format must be
configured. Configure a Wiegand card format for the HandKey reader. This will be used to configure the
smart card.
Configuring the Smart Card Format
1.
Under the Card Format tab:
a.
Type in a unique name for the card format.
b.
For Application, select HandKey (MIFARE) or HandKey (iCLASS).
c.
If Store Reject Threshold is checked and the custom reject threshold was set during capture, then
the custom value will be encoded as well. During verification, the reader will check if there is a
custom threshold encoded on the card. The custom threshold will be used if it is available;
otherwise, it will use its pre-programmed default reject threshold.
d.
Type in the Application Key that matched the key hard-coded in the reader. They key must be
entered in a 12-digit hex format for MIFARE, or 16-digit hex format for iCLASS.
e.
For MIFARE, the Application Sectors should be 2,3. For iCLASS, the memory configuration
should be one of the following:
–
2K Bits/2 Application Areas
–
16K Bits/2 Applications Areas
–
16K Bits/16 Application Areas
f.
Leave the default setting for the card layout (for both MIFARE and iCLASS).
2.
Assign the smart card format to the badge type.
a.
On the Badge Type screen, select the badge type and click [Modify].
b.
Under the Encoding tab, click [Add].
c.
Select the card format configured in the previous step. Click [OK].
d.
On the Badge Type screen, click [OK]. The badge type is now configured for the HandKey
application.
3.
Encode the MIFARE or iCLASS card with HandKey.
a.
Once a cardholder has a hand geometry template captured and the correct badge type assigned,
click [Encode].
b.
Select the HandKey application.
c.
Click [Encode] in the Encode Badge screen.
d.
Choose the encoder and click [Encode]. Follow the instructions displayed on the screen.
e.
Once encoding is complete, a message box will appear to confirm. Click [OK].
596 —
revision 7
Advertisement
Table of Contents
