Lenel OnGuard Hardware Installation Manual page 351

64.1.5 EOL Termination
Jumper J4 is used to configure the EOL termination status the Single Reader Interface Module board. There
are two possible configuration options that can be used to install this jumper: "On" and "Not On."
J3 in ON position (Cabinet Tamper is bypassed)
J3 in OFF position (requires wiring)
J3
Termination ON position for J4
J4
Termination OFF position for J4
J4
Hardware Installation Guide
J3
Cabinet T amper
Normally open contact
351
revision 7 —