81.2
Elevator Control
Currently, elevator control is supported for up to six floors on the Dual Reader Interface Module.
In order to use Elevator Control, your software must be configured for it. This can be done in System
Administration on the Readers window.
On the Dual Reader Interface card, Reader 2 is not used. Only Reader 1 is used. The six aux outputs are used
to control the six corresponding floor buttons.
Supply Power to the Interface
+
12 to 24 VDC
-
Access
Control
System
Maximum: 500 feet
6 conductors
(inside cab)
Hardware Installation Guide
VIN
GND
Intelligent System Controller
Dual Reader
Interface
Module
6 Inputs
6 Outputs
2 Aux. Inputs for Reader 1 only
Elevator Control Room
Elevator
Up to 6 floors can
Reader
be supported
419
revision 7 —