Table of Contents
Advertisement
Biometric Readers
Pigtail
from
reader
628 —
revision 7
Wiring of V-Pass FX with Series 2 LNL-1300
Network Identification Number
MUST be set to 0.
Signal Ground (Black/Red)
Green/Yellow
Tie to Earth Ground
TYPICAL SOFTWARE SETTINGS
(Note: Software version 5.12.12 or higher required for Series 2 single
reader interface module.)
1.
Reader Type = (Bioscrypt RS-485)
9-24 VDC
Power Supply
(DC- must tie
into Signal
Ground)
GND
RS-485 + (Blue)
CLK/D1
RS-485- (Blue/Black)
DATA/D0
Single Reader
Interface Module
BZR
LED
VO
Advertisement
Table of Contents
