Table of Contents
Advertisement
ISC Communications
41.7.1
Configuration of the SDS1100/1101/CoBox-FL
To configure this Lantronix device, perform the following procedures. You may configure through a telnet
connection over the network, or a terminal program over a serial connection. For more information, refer to
the Lantronix User Guide.
Notes:
These instructions also apply for the CoBox-FL, with the exception of encryption. Encryption
is not available on the CoBox-FL.
Encryption using the Lantronix SDS is supported only for third-party devices, and not Lenel
access panels. Ensure that encryption is turned off for use with Lenel access panels.
Using Telnet
1.
From the command prompt, type the following to enter the configuration menu:
telnet <IP Address> 9999
Or, in Unix:
telnet <IP Address>:9999
This command will open the IP Address using port 9999, which is reserved for configuration.
2.
Press <Enter> to go into the setup mode. The Change Setup menu is displayed.
3.
Type the number of the option you would like to access. Press <Enter>.
4.
Select the option which you would like to change and type in the new value. If you would like to just
confirm the current setting, do not type anything. Press <Enter>.
5.
Select 0 for Server, the device's current settings are displayed.
232 —
revision 7
Lantronix SDS settings
Change Setup menu
Advertisement
Table of Contents
