Table of Contents
Advertisement
12. For flow control, type:
change flow control [FLOW CONTROL]
and press <Enter>, where [FLOW CONTROL] = xonoff, ctsrts, slowcts, or none.
13. Type
change dedicated tcp port=3001
and press <Enter>.
14. (Optional) If you are going to connect to the device from across subnets or routers, you will need to
program the subnet mask and gateway. The commands are:
•
change subnet mask [your subnet mask]
•
change gateway [your gateway]
15. Type in the following to disable BOOT and RARP, depressing the <Enter> key after each line.
LOCAL>>CHANGE BOOTP DISABLE
LOCAL>>CHANGE RARP DISABLE
16. Type change access remote and press <Enter>.
17. Disconnect from the device and exit.
18. If a subnet mask and gateway was programmed (step 9), you must recycle power to the device (the
device must be rebooted) in order for the settings to take effect.
19. At this point, make sure that switch 5 on the ISC is configured correctly for hardware flow control. It
should be set to "ON."
20. To verify that the device is talking on the network you can "ping" the device from a command prompt
by typing ping <IP address>.
41.3
LNL-ETHLAN-MICR (Micro Serial Server)
The ETHLAN-LITE/ETHLAN-MICR device plugs directly into the ISC panel. It should be labeled with its
Ethernet/hardware address (example: 00-80-a3-2b-02-3b).
Assign this address to a TCP/IP address over the network by using the ARP utility. In order to do this, the
ARP table on the Windows PC must have at least one IP address other than its own defined. If the ARP table
is empty, the command will return an error message saying that the ARP table addition failed.
Note:
Using the ARP utility may require administrator rights.
1.
At the command prompt, type ARP-A to verify that there is at least one entry in the ARP table. If there
is at least one entry, proceed to step #3.
2.
If there is no other entry listed in the ARP table besides the local machine, ping another IP machine on
the network to build the ARP table. You must ping a host other than the machine on which you are
working.
3.
After the entry is listed in the ARP table, use the following command to ARP the IP address:
arp -s <IP Address> <Ethernet/Hardware Address>
where the <IP address> is the numerical address (example: 192.168.002.203) and the <Ethernet/
Hardware Address> is the address labeled on the Micro Serial Server device (example: 00-80-a3-2b-02-
3b).
Hardware Installation Guide
215
revision 7 —
Advertisement
Table of Contents
