Table of Contents
Advertisement
LNL-3300 Intelligent System Controller
Note:
Ensure that DIP switch 1 is off and DIP switch 2 is ON before rebooting to keep board in
default static IP address mode.
33.6
Embedded Web Server
Instead of using DIP switches or jumpers to define communication and addressing, the LNL-3300 can be
configured through the web interface.
33.6.1
Logging in for the First Time
There is one pre-defined user always available by turning DIP switch SW1 ON after power up. When
logging on for the first time, since no other users are defined yet, the default user name and password are
required for configuring this board.
After configuring ports and users, be sure to turn SW1 off to enable the settings you've configured.
Note:
All boards have a static certificate that reflects a static IP address. This causes a warning to
appear initially when trying to log in that states a problem with this website's security
certificate. Although it is not recommended, proceed to the website.
33.6.2
Configuration via Web Page
The Configuration Web Page can be launched from within System Administration (only if an IP address or
host name is specified) or by using a browser to access the programmed IP address. Depending on your
proxy settings, you may have to allow this web page. (For more information, consult your browser's online
help or system administrator for assistance.)
1.
In System Administration in the Access Panels folder, click [Configuration Web Page]. This page will
launch in a browser. (You may also access this page by going to the device IP address from within the
browser.)
2.
Click the link to go to the login page. Log in using your user name and password. (see
Security
Enhancements, on page
3.
The Home page indicates the type of device and has a Notes field. You may type in a description here.
Click [Save Notes].
4.
To configure network settings, click [Network].
•
If you are using DHCP, specify a host name. By default, the host name consists of "MAC" followed
by the numbers of the device MAC address. With DHCP, IP settings will be configured
automatically.
•
For a static IP address, specify the IP address, subnet mask, and default gateway.
•
Click [Accept].
5.
To configure the host, click [Host Comm].
a.
Specify the controller's communication address. This is the address used for RS-485, also must
match the setting in the access control software, even for IP communications.
b.
Configure the following:
178 —
revision 7
117
for details.)
Default Login
Advertisement
Table of Contents
