Table of Contents
Advertisement
ISC Communications
4.
Select Direct Connect and choose the COM port to which the cable is connected on the computer.
5.
Change the Communication settings to: 9600 Baud, 8 data bits, 1 stop bit, and No Parity.
6.
Once in Terminal mode, hold down the <x> key on the keyboard and plug in power to the CoBox
device. The following will appear on the screen (version and serial numbers may be different):
7.
Press <Enter> to go into the CoBox device's setup mode. The CoBox device's current configuration
will be displayed. It will look similar to the following:
8.
Type 0 and then press the <Enter> key to enter the basic setup for the CoBox device.
9.
Enter the IP address for the CoBox device in the form of 10.11.12.13. The currently configured address
will appear as you get to each part of the IP address as you are typing; just continue to type the new
number.
10. The software will next ask you if you wish to set the gateway. Answer yes and type the gateway IP
address just as you did for the IP address of the device. As it did for the device's IP address, the current
configuration information will display at each segment of the IP address.
224 —
revision 7
Advertisement
Table of Contents
