Table of Contents
Advertisement
HandKey Readers
3.
Set the date format.
If the date format is acceptable, press [*/No] to move onto the next option.
Or enter [#/Yes] at the prompt to set the date format. Once you do this, selecting [*/No] will allow you
to pass each current date format. When the preferred date format is displayed, press the [#/Yes] button.
The display will return to the start of the SET DATE FORMAT command. Select [*/No] to move onto
the next menu.
4.
Set the time and date.
If you do not need to set the time and date, press [*/No] to move onto the next option.
Time is kept using a 24 hour clock. The hour is represented by two digits, 00 to 23. The minute is
represented by two digits, 00 to 59. The date is also numerical. The month is represented by two digits
(January=01, incrementing to December=12). The day is represented by two digits, 01 through 31. The
year is represented by two digits corresponding to the last two digits of the current year.
Enter [#/Yes] at the prompt to set the time and date. You will then be asked for the month. Enter the
number for the month and press [#/Yes]. After this, you will be asked for the day. Enter the number,
followed by the [#/Yes] button.
Do the same for the year, hour, and minute.
The display will then return to the start of the SET TIME & DATE command.
5.
Set the address. Each reader must have a unique address.
When the option to set address is displayed, press [#/Yes] to set the reader address. The current address
will appear on the display. To set a new address, type in the number followed by [#/Yes] to set it. The
display will return to the start of the SET ADDRESS command.
6.
For SET ID LENGTH, press [*/No] to pass through this menu option.
7.
Set the reader mode.
Cycle through the options by pressing [*/No] until you reach SET READER MODE. The device will
cycle through the options for SET FACILITY, LOCK/SHUNT TIME, AUX OUT CONTROL; to which
you will press [*/No] to get to SET READER MODE. Press [#/Yes].
When the unit displays TO MASTER, press [#/Yes]. The display will then return to the start of the SET
READER MODE command. Press [*/No] to move onto the next setting.
8.
Set beeper.
Cycle through the options by pressing [*/No] until you reach SET BEEPER. The device will cycle
through the options for SET SERIAL (the default baud rate is 9600), SET DURESS CODE, PRINT
OPTIONS; TO WHICH YOU WILL PRESS [*/No] to get to SET BEEPER. Press [#Yes]. Cycle
through the following settings:
a.
TURN BEEPER OFF, press {*/No].
b.
SET BEEPER, press [*/No].
9.
When UPGRADE is displayed, press [*/No].
10. After cycling through all of these options, you will be returned to SET LANGUAGE. Press [Clear] to
exit the menu.
112.2.3
MIFARE/iCLASS HandKey Reader Operation
The MIFARE/iCLASS HandKey reader has a small slot located on the left side of the device by the reader.
To use the reader:
1.
Place the card into the slot on the left side of the device.
2.
Once the card is read, the display will ask for biometric verification. Follow the instructions displayed.
598 —
revision 7
Advertisement
Table of Contents
