Table of Contents
Advertisement
Access
Apply Setting page
For pages that cannot be viewed, the message is displayed when users attempt to access the page:
"This page is unavailable due to one of the following reasons: your user level is not authorized to
view this page, or another level 1 user is logged in at this time."
b.
Select the password strength.
–
Low - The minimum password length must be six characters. None of the password strength
criteria will be enforced.
–
Medium - The minimum password length must be six characters. Two of the password strength
criteria must be met.
–
High - The minimum password length is eight characters. Three of the password strength
criteria must be met. Additionally, strong passwords are checked to make sure that they are not
based on the user name.
Password strength criteria:
–
Uppercase alphabet characters
–
Lowercase alphabet characters
–
Arabic numerals (0-9)
–
Non alphanumeric characters ` ! ? $ ^ * ( ) _ - + = { [ } ] : ; @ ~ # | < , > . ? /
Characters " , \, &, = and % are invalid characters and cannot be used for passwords.
c.
Specify the Session Timer (5 to 60 minutes). Click [Save].
d.
You may disable the web server by selecting the check box. When this option is selected and SW1
is off, all ports except for the host communication port will be disabled. The configuration web
page cannot be used to access the device.
e.
Select the Enable door forced open filter check box if you do not want a forced open alarm if the
door is opened within three seconds of it being closed.
8.
For configuration of auto-save, click [Auto-Save].
a.
On this page, you may restore the last save or clear all the settings.
b.
Choose to disable or enable Auto-Save. If Auto-Save is enabled, volatile memory is written to
flash. The frequency of this action is specified in the timer (30 seconds to 30 minutes). Click [Save
Settings].
9.
You may click [Restore/Default] if you need to reload the factory settings or the current operating
settings.
10. When you have completed configuring the device, click [Apply Settings], [Apply Settings, Reboot], and
then [Log Out].
View allowed
Level 2: No
Level 3: No
Hardware Installation Guide
Edit allowed
Level 2: No
Level 3: No
revision 7 —
163
Advertisement
Table of Contents
