Table of Contents
Advertisement
epoxy resin to protect against the environment. The reader may be mounted on a single-gang electrical
utility box, or on any surface (wall, cabinet, etc.).
102.7.1
Installation
1.
Install a single-gang electric utility box, or drill two no. 27 (0.144 inch) clearance holes for the reader's
screws and one hole for the cable, at the desired mounting location. Observe ADA height requirements.
2.
Place the plastic foam pad behind the reader's plastic housing. Line up the opening in the plastic foam
pad with the opening in the reader's housing where the cables pass through the housing.
3.
Pull the reader's short cable (with the 12-pin connector) through the opening in the housing and out the
front of the housing. Pull the long cable (with pigtails) out the back of the housing toward the wall.
4.
Wire the reader's 15-inch-long cable (with gray plastic sheath and 10 pigtails) to the cable from the
reader location to the controller panel. The reader's orange wire must be floating - no connection to
anything.
Mounting dimensions
Hardware Installation Guide
511
revision 7 —
Advertisement
Table of Contents
