Table of Contents
Advertisement
LNL-1100-U Input Control Module
47
Installation
To install the Input Control Module (ICM), perform the installation procedures described in the following
sections, in the order in which they are presented.
1.
Set baud rate (SW1), address (SW2), and LED control switches.
2.
Install jumpers.
3.
Mount the board in the enclosure.
Note:
The LNL-CONV-U1 Universal Mounting Plate is required when installing the board into a
CTX enclosure. For more information, refer to Mounting on page 288.
4.
Wire the unsupervised alarm inputs for power fault and cabinet tamper.
5.
Wire the supervised alarm inputs.
6.
Wire the upstream host communication.
7.
Wire the relay outputs.
8.
Wire the power and communications inputs.
9.
Validate proper operation on power up.
282 —
revision 7
Advertisement
Table of Contents
