Table of Contents
Advertisement
LenelProx Readers
4.
Connect the reader to the controller panel according to the following figure.
Receive (Orange )
Transmit (Violet )
Hold (Blue)
Beeper (Yellow )
LED (Brown)
Data1 (White)
Data0 (Green)
Ground (Black)
5-12 VDC (Red)
Shield (Drain)
Connect the yellow wire only if used for Beeper control by the panel.
Connect the blue wire only if used for Hold control by the panel.
Do not connect the orange and violet wires to anything. Tape or cap the unused wires singly.
5.
Use a Lenel regulated power supply with linear output, between 5 volts (250 mA) and 12 volts DC
maximum (600 mA peak). Do not power the LPMR-1824 from the panel's reader input port. Tie the
ground side of all DC power supplies together – including the reader, the panel's input port, and the
door/gate release.
6.
To install the reader's cable through the surface directly behind the reader, insert both cable slot plugs in
the sides of the reader's top cover. To run the cable exiting from the side of the reader, press-fit the cable
into the curved channel and guide the cable out of the desired side of the reader. Then insert the cable
slot plug in the other side of the top cover.
7.
Install the reader on the mounting surface, using screws and anchors as necessary.
8.
Power up the reader. The LED is steady amber. (The beeper does not sound.)
9.
Present any valid Lenel proximity credential (card, key tag or wafer) briefly to the reader. The beeper
sounds a single short beep. The LED is steady red to indicate standby mode. The reader is initialized
and prepared to read cards.
Note:
All credentials must be Lenel's own products.
10. The LED color in standby mode may be changed from red to green, or from green to red, using a Color
Changer card, available from Lenel. Remove power from the reader for a few seconds, then restore
power. While the LED is amber, present the Color Changer card to toggle the LED color at standby.
516 —
revision 7
Wiring diagram (Wiegand)
READER
EARTH
GROUND
CUT
READER INTERFACE
MODULE
Buzzer
LED
Data1
Data0
Ground
Power
Chassis Ground
Advertisement
Table of Contents
