Table of Contents
Advertisement
LNL-1300e Single Door IP Interface Module
68.3
Using Static IP Addressing
Setting the DIP switches to "0010" enables communication to the LNL-1300e via the programmed static IP
address. The user can then simply address the LNL-1300e by using the static address.
68.3.1
Programming the Static IP Address
Setting the DIP switches to "0011" allows you to program the static IP address. For more information, refer
to
Set DIP Switches to Addressing Mode
The programming of the static IP address is accomplished by a separate utility (Address Configuration Tool
version 1.0.5 or later) available on the Supplemental Material disc. This utility is used to leverage the native
addressing of the LNL-1300e in order to set a permanent static IP address. This utility is intended to be used
in an isolated test setting.
In order to program the LNL-1300e, complete the following steps:
1.
Open the address tool.
2.
Set the LNL-1300e to the programming mode.
3.
Select the LNL-1300e to be programmed from the Devices in Programming Mode listing window.
4.
Move the cursor to the beginning of the Static IP Address field, and then enter the IP address. Continue
with the subnet mask and default gateway.
370 —
revision 7
on page 369.
Advertisement
Table of Contents
