Table of Contents
Advertisement
Biometric Readers
d.
On the Biometrics tab,
–
Change the Global Security Threshold to Very High.
Note:
If a level of security is defined in OnGuard other than "Very High," it will override this reader
configuration.
–
Make sure that the Biometric Verification is Enabled, and that Finger Required (under
Template Security) is selected.
–
Select the number of fingers required and enter the Inter-Finger Timeout in seconds.
–
If you wish, you may enable Password Verification (this will only apply to V-Station-G and V-
Station-H units).
Note:
Remember that if a cardholder PIN is modified in the OnGuard software, it must also be re-
encoded on the smart card!
–
If duress finger is used, the Duress Finger Mode must be Enabled. Otherwise, it is Disabled.
e.
On the Verification Response tab, make sure Verification Polling Mode is Disabled.
f.
The default settings may be left on the General Purpose I/O tab (GPO 0=No Action).
646 —
revision 7
Advertisement
Table of Contents
