Table of Contents
Advertisement
LenelProx Readers
a.
Connect the LPSP-6820-LR test unit, which is part of the Installation Kit, to the reader cable. Use
the wiring list in the Installation Instructions. Apply power to the reader and the test unit, using the
plug-in DC power module in the Installation Kit.
b.
Use either a WS tag that is attached firmly by its adhesive to a rectangle of windshield glass, or a
MT tag for verification. Hold the tag so that the hand does not interfere with direct line-of-sight
between the tag and the reader.
c.
Move the tag into the field. Observing the LPSP-6820-LR test unit, there is a brief LED color
change and a beep to indicate each read of the tag by the reader. Reads will repeat at a rate that is
determined by the reader's firmware.
d.
Move the tag from side to side, and at varying distances from the front of the reader housing, to
determine the space in which the tag and reader are active.
6.
Mount the reader.
a.
Check to ensure that all connections are secure. Feed all wires through the cable access hole to the
rear or the side of the mounting position.
b.
Mount the reader using fasteners on the aluminum plate to which the LPLR-911 reader is attached.
Drill holes through the plate as required by the application, or attach flexible mounting devices or
clamps.
c.
Adjust the position or the angle of the reader so that the tags (which have been fastened by adhesive
to the windshield or other surface) are detected and read at the desired distance from the reader.
102.9.3
LPLRIN Installation Kit
The installation kit consists of the following components:
•
one LPSP-6820-LR test unit with LED and beeper, and cable with three spring-clips
•
one LPWS tag, mounted on a windshield glass square
•
one LPMT tag
•
one LPPS12-1A power supply for LPLR-911 with cable and two spring-clips
•
one RS-232 adapter cable with 9-pin "D" serial connector, and cable with three spring-clips
The LPSP-6820-LR test unit is connected to the LPLR-911 reader only during test and alignment of the
reader. It has a red-green LED and a buzzer, providing visible and audible feedback to the installer every
time that the tag is read.
Use the tag that is attached to the windshield glass sample to test the installation. The glass must be in
between the reader and the tag. Be sure that the fingers and the hand do not come between the reader and the
tag.
Hold the glass with the LPWS tag in the approximate position where tags will be mounted inside the
vehicles' windshields. Adjust the reader on its adjustable mounting until the LED and beeper indicate
repeated reading (at a rate of about three per second).
102.9.4
Specifications
•
Cable to Controller: 9 conductor stranded, 22 AWG, with continuous shield for typical installation
•
Read Range: 9-11 feet (2.75-3.35 meters)
•
Weight: 37.5 oz.
•
Operating Parameters:
526 —
revision 7
Advertisement
Table of Contents
