Table of Contents
Advertisement
Important:
5.
When the configuration is complete, click [Assign Static Address].
6.
If the device was assigned correctly, it will display the information in the "Current IP Configuration"
and "IP Address Assignment History" sections.
7.
Make a note of the IP address, return the DIP switches to the "0010" setting, and then press S2 to use
the LNL-1300e in the static IP addressing mode.
68.4
System Administration Configuration
From System Administration, complete the following steps:
1.
From the Access Control menu, select Readers and Doors.
2.
On the General tab:
a.
Enter a Name for the LNL-1300e.
b.
Select the Panel.
c.
Assign the "LNL-1300e (IP Interface)" Type to the panel.
d.
Select the reader Output type.
e.
Select the network addressing mode from the Port drop-down. Choose either "Static IP" or
"DHCP" if the LNL-1300e is using public DHCP addressing.
f.
Based on the selected addressing mode, enter the IP Address or Mac Address.
Important:
3 digits must be entered in the address field, including leading zeros.
Make sure the addressing information in System Administration matches what
was configured for the LNL-1300e device on the network.
Hardware Installation Guide
371
revision 7 —
Advertisement
Table of Contents
