Specifications - Lenel OnGuard Hardware Installation Manual

LNL-1200-U Output Control Module
61

Specifications

Note: For UL installations, refer to section
The LNL-1200-U is for connection to low voltage, class 2 power-limited circuits only. These specifications
are subject to change without notice.
• Primary power: 12 to 24 VDC + 10%
- 12 VDC @ 805 mA nominal
- 24 VDC @ 407 mA nominal
- 33 BTU/hour
• Relay contacts: 16 Form-C contacts: Relay 1-16 (K1-K11, K16-K20), 5 A @ 30 VDC
• Inputs:
- One (1) unsupervised, dedicated external (cabinet) tamper
- One (1) unsupervised, AC power fail
• Upstream communication: RS-485 2-wire, 2400 to 38400 bps
- Does not support encryption
• Cable requirements:
- Power: 1 stranded twisted pair, 18 AWG
- RS-485: 24 AWG, 120 ohm impedance, stranded twisted pair(s) with shield, 4000 feet (1219 m)
maximum
- Inputs:1 stranded twisted pair, 30 ohms maximum
- Outputs: as required for the load
• Mechanical:
- Dimension: 5 x 8 x 1.25 in. (127 x 203 x 32 mm)
- Weight: 12.2 oz. (346 g) nominal
• Environmental:
- Temperature: -10 to +70°C (14 to 158° F) operating, -40 to +85°C (-40 to 185°F) storage
- Humidity: 10% at 93°C (199°F) non-condensing operating, 10 to 95% at 85°C (185°F) non-
condensing storage
• Certifications:
- FCC Part 15
- ETL 294, s319
- UL294, 1076
- C-Tick N22193
- CE marking
- RoHS
- Environmental class: Indoor dry
- WEEE
332 —
revision 7
UL Listed Installations on page 331.