Lenel OnGuard Hardware Installation Manual page 500

LenelProx Readers
2. Snap open the reader's top cover by inserting a screwdriver blade into the slot at the bottom edge of the
cover, then twisting the blade gently.
3. Connect the reader to the access control panel according to the following figure(s). Tape or cap the
unused wires singly.
• Wiring with reader interface modules:
Use the following tables to wire the LenelProx LPSL-6820 with either the single or dual reader
interface module. Since the current requirements for these readers range from 40 to 120 mA, this
means that the readers can be powered from the reader interface modules.
Wiring the LPSP-6820 and the LNL-1300
From LNL-1300
Reader Pin
Terminal
GND
BZR
LED
TB4
CLK D1
DAT D0
V0
Wiring the LPSP-6820 and the LNL-1300-U
From LNL-1300-U
Reader Pin
Terminals
GND
J10 DAT D0
CLK D1
LED1
LED2
J13
BZR
V0
500 —
revision 7
To LPSP-6820 Reader
Wire Color Description
Black Ground
Yellow Beeper
Brown LED
White Data 1
Green Data 0
Red 5 - 12 VDC
To LPSP-6820 Reader
Wire Color
Black Ground
Green Data 0
White Data 1
Brown Green LED
Not connected Not connected
Yellow Buzzer
Red 5-12 VDC
Typical Software Settings
• Reader Type = Wiegand/Prox
• Keypad = No Keypad
• LED Mode = 1-Wire LED
Control
Typical Software Settings
Description • Reader Type =
Wiegand/Prox
• Keypad = No Keypad
• LED Mode = 1-Wire
LED Control