Table of Contents
Advertisement
48
Configuration
The Input Control Module board contains two (2) 8-position DIP switches that are user-selectable to control
addressing, baud rate, and other user functions, and one (1) RS-485 termination jumper used to configure the
system.
48.1
Setting DIP Switches
48.1.1
Communication Baud Rate (SW1)
Configure the baud rate using SW1 switches 1 and 2. (Switch 5 is used for LED control. Switches 3, 4, and
6 through 8 are not used.)
Baud rate
2400 bps
9600 bps
19200 bps
38400 bps
ICM dip switches
SW1 switch for host
1:
2:
off
off
ON
off
off
ON
ON
ON
Hardware Installation Guide
283
revision 7 —
Advertisement
Table of Contents
