Huawei NetEngine80E Configuration Manual - Reliability page 1356

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
The following operations must be performed on the active and standby CGN devices.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
service-location service-location-id
The service-location view of the HA backup group is displayed.
Step 3 Run:
vrrp vrid virtual-router-id interface interface-type interface-number
The HA backup group is bound to a VRRP backup group.
----End
Configuring Association Between HA and VRRP
This section describes how to configure association between HA and VRRP in the interface
view.
Context
After association between HA and VRRP is configured, VRRP tracks HA status in real time and
determines whether to perform an active/standby switchover.
The following operations must be performed on the active and standby CGN devices.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
vrrp vrid virtual-router-id track service-location service-location-id [ reduced
value-reduced ]
Association between an HA backup group and a VRRP backup group is configured.
Issue 02 (2014-09-30)
NOTE
Values of service-location-id must be the same on the active and standby CGN devices.
NOTE
Values of virtual-router-id must be the same on the active and standby CGN devices.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
12 CGN Backing Up HA Configuration
1339