Locate The Server - Oracle netra X5-2 Service Manual

Locate the Server

Related Information
"Removing Power From the Server" on page 67
■
"Accessing Internal Components" on page 71
■
Locate the Server
You can use the Locator LEDs to pinpoint the location of a server. This procedure is helpful
when you need to identify one particular server from many other servers.
Access Oracle ILOM.
1.
See "Access the SP (Oracle ILOM)" on page
2. If you have not already done so, enable Oracle ILOM legacy targets.
See "Enable Oracle ILOM Legacy Targets" on page
Turn on the Locator LED.
3.
-> set /SYS/LOCATE value=Fast_Blink
The white Locator LEDs (one on the front panel and one on the rear panel) blink.
After locating the server with the blinking Locator LED, turn the LED off by
4.
pressing the Locator button.
Note -
LOCATE value=off command.
5. Consider your next step.
Service these components:
■
■
■
■
■
Or, remove power from the server.
■
See
Related Information
Server Administration, set command
■
66 Netra Server X5-2 Service Manual • October 2016
Alternatively, you can turn off the Locator LED by running the Oracle ILOM set /SYS/
"Servicing the Filter" on page 89
"Servicing SAS Drives" on page 93
"Servicing the DVD Drive" on page 113
"Servicing Power Supplies" on page 119
"Removing Power From the Server" on page
28.
35.
67.