Install A Pcie Card - Oracle netra X5-2 Service Manual

If you removed a PCIe card as part of another component's removal or installation
■
procedure, return to that procedure. See
for assistance.
If you are not replacing the PCIe card, install a filler panel. See
■
Card" on page
7. Finish the removal procedure.
See "Returning the Server to Operation" on page
Related Information
"Locate a Faulty PCIe Card" on page 138
■
"Install a PCIe Card" on page 141
■
"Preparing for Service" on page 61
■
"Returning the Server to Operation" on page 247
■

Install a PCIe Card

Installing a PCIe card is a cold-service operation. You must power off the server before
installing the PCIe card.
With the single-processor configuration, you can install PCIe cards only in slot 5 and slot
Note -
6. With the dual-processor configuration, all six PCIe slots are available.
This procedure is the same for installing a filler panel.
Note -
1. Consider your first step.
If you are replacing a PCIe card, remove the faulty or obsolete PCIe card first, then return to
■
this procedure,
If you are installing a new or an additional PCIe card, go to
■
If you are installing a PCIe card as part of another component's removal or installation
■
procedure, go to
2. Review this information and complete these prerequisites in this order.
"PCIe Card Configuration" on page 138
■
"Preparing for Service" on page 61
■
"Remove a PCIe Card" on page 139
■
Remove filler panel.
3. Position the PCIe card at the slot where it will install.
141.
Step 3. See "Remove a PCIe Card" on page
Step 3.
"Component Service Task Reference" on page 65
"Install a PCIe
247.
139.
Step
Install a PCIe Card
2.
Servicing PCIe Cards 141