Oracle Ilom Legacy Targets For Component Fruid And Fault States; Display Component Voltages - Oracle netra X5-2 Service Manual

"Display Component Fan Speeds" on page 56
■
"Display Component LED State" on page 57
■
Oracle ILOM Legacy Targets for Component
FRUID and Fault States
Use the Oracle ILOM show command with these targets to display FRUID and faults
states of hardware components. See
Components" on page
Component
CPU Px
DIMM Dy
Drive backplane
Fan module FMx
Motherboard
NETx port
NVRAM or IDPROM
PDB
Power supply PSx
SP
Related Information
"Display FRUID and Fault State for Specific Components" on page 52
■
"Oracle ILOM Legacy Targets for Component Power Consumption" on page 55
■
"Oracle ILOM Legacy Targets for LED States" on page 57
■

Display Component Voltages

Access Oracle ILOM.
1.
See "Access the SP (Oracle ILOM)" on page
2. If not already done, enable Oracle ILOM legacy targets.
See "Enable Oracle ILOM Legacy Targets" on page
"Display FRUID and Fault State for Specific
52.
Target
/SYS/MB/Px
/SYS/MB/Px/Dy
/SYS/DBP
/SYS/MB/FMx
/SYS/MB
/SYS/MB/NETx
/SYS/MB/CPLD
/SYS/PDB
/SYS/PSx
/SYS/SP
28.
Display Component Voltages
Comment
where x is either 0 or 1
where y is 0 to 11, for CPU Px
where x is 0 to 5
where x is 0 to 3
where x is either 0 or 1
35.
Detecting and Managing Faults 53