Oracle netra X5-2 Service Manual page 109

Route the NVMe cable bundle through the cable clips on the motherboard and past the fan
modules on the side of the server. Then, route the cables back to the front storage drive
backplane.
2. Reconnect the NVMe cables to the front storage drive backplane.
Plug each cable into its connector until you hear an audible click.
Reconnect the NVMe cables to the Oracle PCIe NVMe switch card.
3.
Plug each cable into its connector until you hear an audible click.
Use the following table to ensure proper NVMe cable connections.
Each NVMe cable contains a matching label that corresponds to the port on the Oracle
Note -
PCIe NVMe switch card. For example, the NVMe cable labeled 0,1 plugs in to the Oracle PCIe
NVMe switch card port 0,1, and the cable labeled 2,3 plugs in to the Oracle PCIe NVMe switch
card port 2,3.
Disk Backplane Cable
Connector
A
B
Return the server to operation.
4.
See "Returning the Server to Operation" on page
Related Information
"Remove the NVMe Switch Card Cables" on page 108
■
"Remove the NVMe Switch Card" on page 110
■
"Install an NVMe Switch Card" on page 110
■
Oracle PCIe NVMe Switch
Card Port Cable Connector
2,3
0,1
247.
Servicing NVMe Storage Drives, Switch Card, and Cables
Install the NVMe Switch Card Cables
109