Table of Contents
Advertisement
Related Information
"Front Panel Components (Service)" on page 13
■
Locate the Server
You can use the Server Locator LEDs to identify one particular server from many other servers.
1.
At the Oracle ILOM prompt, type:
-> set /System/locator_indicator=on
The white Server Locator LEDs (one on the front panel and one on the rear panel) blink for
about 30 minutes before turning off.
After locating the server with the blinking Locator LED, turn it off by pressing the
2.
Server Locator button.
Alternatively, you can type an Oracle ILOM command to turn off the Locator LED.
-> set /System/locator_indicator=off
Related Information
"Front Panel Components (Service)" on page 13
■
Component Service Categories
The server components and assemblies that can be replaced in the field fall into three
categories:
Hot-service, replaceable by customer
■
Cold-service, replaceable by customer
■
Cold-service, replaceable by authorized service personnel
■
Cold-service procedures require that you shut the server down and unplug the power cables that
connect the power supplies to the power source.
Although hot-service procedures can be performed while the server is running, you should
usually bring it to standby mode as the first step in the replacement procedure. See
the Server (Server Power Button - Graceful)" on page 48
Locate the Server
for instructions.
Preparing for Service
"Power Off
45
Advertisement
Table of Contents
