Remove An Nvme Storage Drive - Oracle netra X5-2 Service Manual

Remove an NVMe Storage Drive

3. At the BIOS prompt, detach the NVMe device driver, and power off the NVMe
drive slot.
echo 0 > /sys/bus/pci/slots/slot-number/power
where slot-number is the slot number obtained in
The slot number can be a single digit or hyphenated numbers such as 0-2.
Related Information
"Remove an NVMe Storage Drive" on page 106
■
"Verify Removal of an NVMe Storage Drive (Oracle Solaris)" on page 107
■
Remove an NVMe Storage Drive
After you unmount the NVMe storage drive, the steps to physically remove the dirve are the
same as the steps to remove a SAS storage dirve. For detailed instructions, see
Drive" on page
1. Unmount the storage drive depending on the OS.
Use one of these methods:
"Unmount an NVMe Storage Drive (Oracle Solaris)" on page 104
■
"Unmount an NVMe Storage Drive (Oracle Linux)" on page 104
■
2. Identify the physical location of the NVMe drive that you want to remove.
For storage drive locations, see
Modules)" on page
3. Verify that the OK to Remove indicator (LED) on the NVMe storage drive is lit.
4. Push the latch release button to open the drive latch.
5. Grasp the latch, and pull the drive out of the drive slot.
6. Consider your next step:
If you are replacing the drive, use one of these methods to verify the
■
removal.
■
■
106 Netra Server X5-2 Service Manual • October 2016
97.
"Component Locations (Storage, Power, and Fan
14.
"Verify Removal of an NVMe Storage Drive (Oracle Solaris)" on page 107
"Verify Removal of an NVMe Storage Drive (Oracle Linux)" on page 107
Step 2b.
"Remove a SAS