Verify the LED Board
If you installed the LED board as part of another component's removal or installation
■
procedure, return to that procedure. See
for assistance.
9.
Review this information and complete these prerequisites in this order.
"Install the Air Duct" on page 249
■
"Secure the Drive Cage" on page 253
■
"Install the Filter" on page 91
■
10.
Complete these postrequisites in this order to finish the installation procedure.
"Returning the Server to Operation" on page 247
■
"Verify the LED Board" on page 218
■
Related Information
"Remove the LED Board" on page 212
■
"Verify the LED Board" on page 218
■
"Preparing for Service" on page 61
■
"Returning the Server to Operation" on page 247
■
Verify the LED Board
After you install the LED board, you can verify its functionality.
Press and hold the Locator button for more than 5 seconds.
All of the LEDs in the LED assembly should light.
Related Information
"Install the LED Board" on page 215
■
"Determine if the LED Board Is Faulty" on page 211
■
218
Netra Server X5-2 Service Manual • October 2016
"Component Service Task Reference" on page 65