Power Supply Leds; Locate A Faulty Power Supply - Oracle netra X5-2 Service Manual

Power Supply LEDs

Power Supply LEDs
The status of each power supply is represented by three LEDs. The LEDs are located to the left
of the fan of each power supply. See
functionality of the power supply LEDs.
Icon Location
Top
Middle
Bottom
Related Information
"Locate a Faulty Power Supply" on page 120
■
"Remove a Power Supply" on page 122
■
"Front Panel LEDs" on page 31 "Rear Panel LEDs" on page 33
■

Locate a Faulty Power Supply

You must determine which power supply is faulty before you replace it.
Check to see if any System Service Required LEDs are lit or flashing.
1.
See "Interpreting Diagnostic LEDs" on page
2. Visually inspect the power supplies to see if any of their status LEDs are lit or
flashing.
See "Power Supply LEDs" on page
If a power supply is faulty, replace it. See
3. In Oracle ILOM, check the health of the power system.
-> show /System/Power
/System/Power
Targets:
Properties:
health = OK
120 Netra Server X5-2 Service Manual • October 2016
Name Color
OK Green
Attention Amber
Service Required
AC or DC Green
"Rear Panel LEDs" on page
State and Meaning
On – Power supply is functional without fault.
Off – Power supply is off, in standby mode or initializing.
On – Normal fault detected.
Off – No faults detected.
On – Input power present and good.
Off – Input power not present.
30.
120.
"Remove a Power Supply" on page
33. This table describes the
122.