Oracle netra X5-2 Service Manual page 102

Verify a SAS Drive
3. Consider your next step.
If you installed a new drive as part of a replacement operation, verify that the drive
■
is no longer considered faulty, then return to this procedure. See
Drive" on page
If you installed a new drive to increase functionality, go to
■
4. If the OS is shut down, and the drive you replaced was not the boot device, boot
the OS.
Depending on the nature of the replaced drive, you might need to perform administrative
tasks to reinstall software before the server can boot. Refer to the OS documentation for more
information.
5. Verify that the blue Ready-to-Remove LED is no longer lit on the drive that you
installed.
See "SAS Drive LEDs" on page
6. If the previous steps indicate that the drive is functioning properly, perform the
tasks required to configure the drive.
See the OS documentation.
Related Information
"Install a SAS Drive" on page 99
■
"SAS Drive Configuration" on page 94
■
"SAS Drive LEDs" on page 94
■
"Locate a Faulty Drive" on page 95
■
102 Netra Server X5-2 Service Manual • October 2016
95.
94.
"Locate a Faulty
Step 4.