Access The Sp (Oracle Ilom) - Oracle netra X5-2 Service Manual

Access the SP (Oracle ILOM)

"Tools Available When the BIOS Menu Is Available" on page 26
■
"Tools Available When the OS Is Running" on page 28
■
Tools Available When the OS Is Running
In this server state, the boot sequence is finished, the OS is running, and applications are
available.
Tool
Status LEDs:
■ Power supply
■ Chassis
■ Hard drive
■ Network
Oracle ILOM /SP targets
Oracle ILOM logs
Oracle ILOM /System targets
Oracle ILOM show faulty command
Oracle ILOM faultmgt shell
Oracle ILOM legacy targets
Diagnostic applications
Related Information
"Diagnostic Tools" on page 24
■
"Tools Available When Power Cords Are Attached" on page 25
■
"Tools Available on Initial Power Up" on page 26
■
"Tools Available When the BIOS Menu Is Available" on page 26
■
"Tools Available When the OS Boots" on page 27
■
Access the SP (Oracle ILOM)
To run diagnostic and troubleshooting command outside of the OS and host console, you must
first access the SP and log on as a user recognized by the SP.
Note -
shell commands executing concurrently under each account.
28 Netra Server X5-2 Service Manual • October 2016
You can log into multiple SP accounts simultaneously and have separate Oracle ILOM
Links
"Rear Panel LEDs" on page 33
"Front Panel LEDs" on page 31
"Troubleshooting (Oracle ILOM /SP Targets)" on page 34
"Display Oracle ILOM Log Entries" on page 35
"Determining Component Health" on page 43
"Display Faults (show faulty Command)" on page 47
"Display Faults (faultmgmt Shell)" on page 48
"Troubleshooting (Oracle ILOM Legacy
Targets)" on page 51
Refer to your application documentation.