Remove A Sas Drive - Oracle netra X5-2 Service Manual

See "Detecting and Managing Faults" on page
Related Information
"Remove a SAS Drive" on page 97
■
"SAS Drive Configuration" on page 94
■
"SAS Drive LEDs" on page 94
■
"Verify a SAS Drive" on page 101
■
"Detecting and Managing Faults" on page 21
■

Remove a SAS Drive

Removing a SAS drive is a hot-swap operation. You must run commands on the server before
you remove the drive.
Determine which drive to remove.
1.
See "Locate a Faulty Drive" on page
2. Consider your next step.
If you have not prepared for service, do so now. See
■
If you are removing a drive as part of another component's removal or installation
■
procedure, go to
3. Remove the filter.
See "Remove the Filter" on page
4. Determine if you need to shut down the OS to remove the drive, and perform one
of these actions.
If the drive cannot be taken offline without shutting down the OS, follow instructions in
■
"Power Off the Server (Power Button - Graceful)" on page 69
If the drive can be taken offline without shutting down the OS, go to
■
Take the drive offline according to your OS.
5.
See your OS documentation.
6. Verify that the drive's blue Ready-to-Remove LED is lit.
See "SAS Drive LEDs" on page
95.
Step 3.
89.
94.
21.
"Preparing for Service" on page
then go to
Servicing SAS Drives
Remove a SAS Drive
61.
Step 7.
Step 5.
97